BOX 21 - Kits 81-82-83-84

Kit 81 - DASHBOARD LEFT PANEL

Parts of number 081

  • 81A Dashboard left panel 
  • 81B Switch (x 3) 
  • 81C Switch clip (x 3) 
Step 1
Take the left side panel of the dashboard (81A) and place it with the inside facing upwards.

Step 2

Engage the three switch clips (81C) into the slots as shown in the photo. 

Step 3

Flip the panel (81A) and place the three switches (81B) on the three clips (81C).

GENERAL VIEW

Kit 82 - DASHBOARD PANEL (2)

Parts of number 082

  • 82A Dashboard right panel 
  • 82B Top fastener (x 2) 
  • 82C Side fastener (x 2) 
  • Screw AP P 1.7 x 4 mm (x 8) 
Step 1

Take the left panel (81A) and place it with the inside facing upwards. Place a fastener (82C) on the upper corner and secure with an AP screw. Then place the left panel (81A) on the side of the dashboard panel (80A) and secure it with a second AP screw.

Step 2

Take the right panel (82A) and place it with the inside facing upwards. Place a fastener (82C) on the lower corner and secure with an AP screw. Then position the right panel (82A) on the side of the dashboard panel (80A) and secure it with a second AP screw.

Step 3

Hold the dashboard panel (80A) with the inside side facing up. Position the two fasteners (82B) near the top edge as shown in the photo and secure with two AP screws.

GENERAL VIEW

Kit 83 - DASHBOARD PANEL (3)

Parts of number 083

  • 83A Upper dashboard panel 
  • 83B Fastener (x 2) 
  • Screw AP P 1.7 x 4 mm (x 5) 
Step 1

Take the top panel (83A) and place it with the inside facing upwards. Position fasteners (83B), short side, on the upper panel housings and secure with an AP screw.

Step 2

Position the entire dashboard assembly 82 on the panel (83A), engaging the ends of the fasteners (82B) in the corresponding housings. Then secure the clips with two AP screws.

GENERAL VIEW

Kit 84 - DASHBOARD PANEL (4)

Parts of number 084

  • 84A Indicator and rev counter 
  • 84B Rear indicator cover 
  • 84C Indicator light strip 
  • 84D Steering column support 
  • 84E Lower dashboard panel plate 
  • 84F Dashboard button 
  • Screw AP 1.7 x 4 mm (x 3) 
  • Flat head screw RP 1.7 x 3.5 mm (x 3) 
Step 1

Position the indicator light strip (84C) in the slot provided on the dashboard panel (80A). Check the correct orientation of the bar (photo step 2). Then position the indicator and the rev counter (84A).

Step 2

Place the rear indicator cover (84B) on the dashboard panel and secure with two AP screws. Check the final assembly by turning the front of the dashboard panel over.

Step 3

Position the lower dashboard panel plate (84E) on the rear of the dashboard panel as shown in the photo and secure it with two RP screws. Position the button (84F) on the dashboard as per picture.

GENERAL VIEW