BOX 24 - Kits 93-94-95-96

Kit 93 - CENTRAL PART OF THE BODY

Parts of number 093

  • 93A Central part of the body
Step 1
Position the central part of the body (93A) with its lower part facing upwards. Remove the four mounting screws placed at the ends of the support bars with a screwdriver. These bars will not be used later and should be put aside.

GENERAL VIEW

Kit 94 - FRONT SUPPORT AND ROCKER PANEL

Parts of number 094

  • 94A Left front bracket 
  • 94B Right front bracket 
  • 94C Left rocker panel 
  • 94D Right rocker panel 
  • Screw CM M 2.0 x 4 mm (x 3) 
Step 1

Position the bracket (94A) on the bottom of the left front part of the central body (93A) and secure it with a CM screw, as shown in the photo. 

Then position the bracket (94B) on the bottom of the right front part of the central body (93A) and secure with a CM screw.

Step 2

Position the left rocker panel (94C) into the three openings located on the lower left part of the body (93A) (below the door opening) as shown in the photo.

 Then position the right rocker panel (94D) into the three openings located on the lower right part of the body (93A) (below the door opening).

GENERAL VIEW

Kit 95 - WINDSHIELD

Parts of number 095

  • 95A Windshield 
  • 95B Decal LANCIA MARTINI 
  • Screw AM M 1.7 x 4 mm (x 4) 
Step 1

Remove the decal (95B) from its paper backing, DO NOT touch the adhesive surface. Position the sticker at the top of the outer surface of the windshield (95A) by placing it as close as possible to the black edge (windshield seal).

Step 2

Flip the central part of the bodywork (93A) and insert the windshield (95A) from the inside by positioning the three pins located on the bodywork into the openings provided (red circles) on the windshield. Secure the windshield with three AM screws (yellow circle) by tightening gently so as not to break the fixing tabs.

GENERAL VIEW

Kit 96 - LEFT REAR QUARTER WINDOW

Parts of number 096

  • 96A Left rear quarter window 
  • 96B Upper Left rear hinge 
  • Screw AM M 1.7 x 4 mm (x 3) 
  • Screw SM M 1.7 x 3 mm (x 2) 
Step 1

Position the left rear quarter window (96A) on the central body (93A) by first inserting the upper part (red arrow), then secure the window with two AM screws on the lower part (yellow circles).

Step 2

Position the left rear upper hinge (96B) in the opening located on the left upper exterior of the central body (93A) (yellow circle). Keeping it in place, then secure from the inside of the body with an SM screw as shown in the photo.

GENERAL VIEW